Timer-to-Close allows programming in 5-sec or 1-min
increments. Commercial or industrial photo-eyes
required.
Thermal motor overload can be easily reset
from the 3-button floor level control station
Reliability & Programming
Simplicity
Switchless motor eliminates stuck
start switch and motor malfunctions on single-phase
operators
All high-voltage connections have been
removed from the board for safety and ease of
service
Diagnostic LEDs speed installation and
troubleshooting
Motor direction jumper lets you
change motor direction by simply moving a jumper
Mechanical Reversing Contactor Circuit
(M): (115V, 208/230V, 460V, 575V, 24V NEC Class
2 Circuit with 40VA transformer) Industrial linear
contactor provides significantly longer control runs
than conventional contactors.
Standard
Features
Motor:
Continuous-duty high-starting torque motor with instant
reverse and overload protection. Available in 1/3 and
1/2; single- or three-phase. Removable without affecting
limit switch settings.
Door Lock Sensor: Adjustable door
lock sensor can detect if the door lock is engaged and
will stop the operator, eliminating jamming and damage
to the door or operator.
Drive Reduction: First-stage
heavy-duty 5L V-belt; second and third stages #48 chain;
#50 drive chain.
Emergency Disconnect: Easy emergency
manual operation using an electrically interlocked floor
level disconnect and hoist mechanism.
Wiring Type: D1, C2 and B2 wiring
types are all available. D1 wiring is standard and is
pre-wired to accept a photoelectric control, sensing
edge, radio controls and most types of access control
devices. Failsafe wiring can be selected with the
addition of a CPS-L, CPS-LN4 or failsafe edge and CPS3
card.
External Radio Control Terminal:
Quick, convenient connections for retrofitting or adding
radio controls on logic or mechanical operators.
Bearings: Industrial ball bearings
on a 1" output shaft; heavy-duty oil-filled iron
bearings on reduction shafts.
Friction Clutch: Adjustable, helps
protect against major damage to door and operator should
the door meet an obstruction.
Construction: NEMA 1 type electrical
box, heavy-duty 11-gauge steel frame with durable
powdercoat finish, all reduction sprockets drilled and
pinned to shafts.
Push Button Station: 2-button
station for open/close functions is standard with D or
D1 wiring. 3-button station is standard with B2 or C2
wiring.
Positive Locking Mechanical Brake System:
Self-locking mechanical reduction system that
functions as a holding brake.
Control
Accessories
CPS Commercial Protector
System: (recommended) A non-contact photo
safety sensor designed to sense an obstruction and
signal the door operator to reverse to open.
Sensing Edge: (recommended) Designed
to sense an obstruction and signal door operator to stop
or reverse as desired. An electric or pneumatic sensing
device can be added to bottom edge of door.
2-Position Keylock (flush mount):
Ideal for use with the DJ operator. Provides
open/close operation with spring to center (Model
02-109).
Available Plug-in Options for
Logic 3.0 (L3)
Auxiliary
Contact: Used to operate security, warning,
heating or other 5V to 240V devices. Features both
normally open and closed contacts that actuate in
conjunction with limit switches.
Warning Signal: Red/green light
module provides safety warning prior to close (when
using timer-to-close feature). Also supports audio
warning devices and includes down mid-stop feature.
CPS3 Option: Enables the addition of
a second set of photo-eyes or 2- or 4-wire,
self-monitoring edge.
